If you have been reading about lyophilized powder and want a single page that covers the useful parts, this is it: definitions, context, how it is studied, and the questions that come up repeatedly.
Updated 2026-02-03. Numbers and descriptions here follow the published literature rather than marketing material.
In its usual supplied form, the peptide is a white to off-white lyophilized powder that dissolves readily in water and in aqueous buffers. Powder keeps far longer than solution, so material is normally shipped and stored dry, then dissolved only when needed. Once in solution, the chain is subject to hydrolysis and the liquid supports microbial growth, and practical guidance generally treats the dissolved form as short-lived. Containers should stay sealed and desiccated, because the powder takes up moisture from air.
Long-term storage of the dry powder is typically described at minus twenty degrees Celsius or colder, while shorter holding periods may use ordinary refrigeration. Repeated warming and cooling cycles are discouraged because they stress the material and can promote aggregation or loss. Light exposure and residual moisture are both treated as avoidable sources of degradation, and working aliquots are often prepared to limit how many times a container is opened. Sealed vials with a desiccant are the usual container.
Quality assessment rests on two separate questions: whether the chain is the intended one, and how much of the sample is that chain. Reverse-phase high-performance liquid chromatography with ultraviolet detection is the standard purity measurement, while mass spectrometry confirms identity through the observed molecular mass. Amino acid analysis and sequence verification provide further checks. A reported purity percentage describes the proportion of the sample represented by the main peak, not the amount of peptide by mass, since counter-ions and water make up part of any lyophilized lot.
Supplied material is typically a lyophilized white to off-white powder. The peptide is freely soluble in water and in common aqueous buffers, which allows it to be handled as a stock solution. Because the sequence contains no cysteine, disulfide cross-linking is not a route of degradation. The absence of aromatic residues means ultraviolet absorbance at 280 nm is minimal, so quantification usually relies on peptide bond absorbance near 214 nm or on amino acid analysis.
Common synonyms in catalogs include pentadecapeptide BPC 157, BPC157, and the full sequence name. A CAS registry number in the 137525-51-0 range is frequently listed, though the assignment should be verified against the supplier certificate of analysis. The name itself is not a pharmacopoeial designation, and there is no standardized international nonproprietary name. Distinguishing genuine material from related fragments generally requires mass spectrometry, since several truncated sequences share similar chromatographic behavior.
| Property | Value | Notes |
|---|---|---|
| Appearance | White to off-white powder | Freeze-dried cake or loose powder after lyophilization |
| Solubility | Freely soluble in water | Also dissolves in aqueous buffers; solutions are less durable than the powder |
| Typical storage temperature | Minus 20 degrees Celsius or below | Desiccated and protected from light; avoid repeated freeze-thaw cycles |
| Identity method | Electrospray mass spectrometry | Compared against the expected mass; paired with sequence or composition analysis |
| Purity method | Reverse-phase HPLC with ultraviolet detection | Reports main-peak percentage rather than peptide content by mass |
Identity and purity are usually assessed by reversed-phase high-performance liquid chromatography, which separates the target peptide from truncated sequences and other synthesis by-products. Mass spectrometry, typically electrospray ionization coupled to liquid chromatography, confirms the expected mass and helps detect modifications. Amino acid analysis can verify composition when residue-level confirmation is needed. Because common impurities differ from the target by only one or two residues, chromatographic resolution often matters more than a single headline purity percentage. Impurity profiles are most informative when compared against a validated reference standard.
Lyophilized material is generally reported as stable for extended periods when kept cold, dry, and protected from light. In solution, the main degradation routes for a peptide of this type are hydrolysis of peptide bonds and aggregation. The sequence contains no cysteine, so disulfide-driven oxidation is not a primary concern, though methionine and tryptophan are also absent. Stability depends on pH, buffer composition, and concentration, with acidic conditions often reported as more favorable than neutral or alkaline ones. Repeated freeze-thaw cycles can promote aggregation, and how fast degradation proceeds at room temperature in specific formulations remains an open question.
Handling practice centers on limiting moisture, heat, and mechanical stress. Powder is typically allowed to reach room temperature before opening so that condensation does not form on the contents, and solutions are prepared with sterile or low-particulate water. Peptides can adsorb to certain plastics and membrane filters, so container and filter material is sometimes specified to reduce losses at low concentrations. Working aliquots are usually frozen separately rather than sampled repeatedly from one stock. Recording lot number, preparation date, and storage conditions supports later comparison between experiments.
Lyophilized material is generally kept cold, commonly at minus twenty degrees Celsius, and shielded from moisture and light. Solutions are less stable than the dry powder, so repeated freeze-thaw cycles are avoided by splitting the material into single-use portions. Published stability data for this particular peptide are limited, which means suggested hold times should be read as provisional. Long-term refrigeration of reconstituted solutions is not well supported by available evidence.
Identity and purity are checked with standard peptide techniques. Reversed-phase high-performance liquid chromatography separates the main peak from closely related impurities and yields a percentage purity. Mass spectrometry confirms that the measured mass matches the theoretical value. Amino acid analysis offers an independent check on overall composition. These analytical methods characterize the material itself and reveal nothing about how it behaves in a living system.
In its common research form the peptide is supplied as a lyophilized powder. It dissolves readily in water and in typical aqueous buffers, which simplifies preparation of working solutions. Laboratories usually prepare small aliquots instead of one large volume. The dry material appears as a white to off-white solid with no distinctive odor. Bulk quantities are typically shipped in sealed vials.
BPC-157 is a synthetic peptide composed of fifteen amino acid residues, with the sequence Gly-Glu-Pro-Pro-Pro-Gly-Lys-Pro-Ala-Asp-Asp-Ala-Gly-Leu-Val. Its name derives from body protection compound, a term used for a protein fraction identified in human gastric juice. Researchers in Zagreb first reported the pentadecapeptide in the early 1990s and described it as a stable fragment of that larger protein. The compound is also catalogued as PL 14736 and, in some commercial contexts, as bepecin. Its molecular formula is C62H98N16O22 and its monoisotopic mass is approximately 1419 daltons.
Most published work on BPC-157 consists of preclinical studies, including rodent models of tissue injury, gastrointestinal lesions, and vascular or tendon damage, together with in vitro cell assays. Reviews frequently note that the mechanisms proposed in these papers remain incompletely characterised and that findings have not been confirmed in large randomised human trials. The compound is widely sold as a research chemical rather than a licensed medicine, and labels commonly carry a statement that it is not for human use. Whether any of the reported animal effects translate to humans is an open question rather than an established result.
Terminology in the literature is not fully standardised. Papers and product listings use BPC-157, BPC 157, and the longer phrase stable gastric pentadecapeptide BPC 157 interchangeably, and synonyms such as bepecin or PL 14736 appear in older or company-linked publications. Purity claims and reported masses can also differ between sources because peptide preparations may include counterions, residual solvents, or bound water. This variability complicates direct comparison of results across studies and makes the exact identity and grade of a given sample worth verifying. Discussions of the compound should therefore specify the source, salt form, and stated purity where those are known.
=== Alport syndrome === Mutations to the genes COL4A3, COL4A4 and/or COL4A5 coding for collagen IV lead to Alport syndrome. This will cause thinning and splitting of the glomerular basement membrane. It may present as isolated hematuria, sensorineural hearing loss, and ocular disturbances and is passed on genetically in an autosomal dominant, autosomal recessive, or X-linked manner.
=== Germany === In November 2005, a German translation was launched by the publishing house Computec Media AG. The German edition was thinner than the English original, the covers were slightly changed and the ratings raised. In January 2007 it was changed to a bi-monthly schedule and in July 2007 it was finally shut down.
=== Legal status === In the US, desomorphine is a Schedule 1 controlled substance, indicating that the United States FDA has determined that there are no legal medicinal uses for desomorphine in the United States. It has maintained this status as a controlled substance since 1936. The drug is a Narcotic in Schedule I of the Controlled Substances Act 1970 of the United States as drug number (ACSCN) 9055. It is therefore subject to annual aggregate manufacturing quotas in the United States, and in 2014 the quota for desomorphine was 5 grams. It is produced as a hydrochloride (free base conversion ratio 0.85) and sulphate (0.80).
== History == The Kingdom of Mysore was one of the three largest princely states in British India. Upon India's independence from Britain in 1947, Maharaja Jayachamarajendra Wadiyar signed the instrument of accession, with the Union of India on 9 August 1947. The territories of the erstwhile princely state of Mysore were then reconstituted into a state within the Union, on 26 January 1950, with its administrative integration into the Indian Union. In 1953 during the formation of Andhra, the Bellary district was transferred from Madras to Mysore.
Sources: en.wikipedia.org
Metabolic studies indicate that NAD, once considered a stable molecule, is continuously turned over and used, requiring tight regulation to maintain metabolic homeostasis. NR utilization in mammals may involve both exogenous dietary sources and endogenous salvage processes that recycle intermediates. NR metabolism and the interactions of different NAD pathways continue to be studied. The NAM and NR pathways involve an amide group and are referred to as 'amidated' pathways. The pathways for de novo synthesis from tryptophan and from NA salvage are 'deamidated' pathways, which share a rate-limiting amidation enzyme NADsynthase1 (NADSYN). Disruptions or imbalances in NAD metabolism have been observed in many disease conditions, and the possibility of restoring NAD levels by administering NAD precursors is an area of interest for researchers.
== Chemical properties == Following is a table listing the one-letter symbols, the three-letter symbols, and the chemical properties of the side chains of the standard amino acids. The masses listed are based on weighted averages of the elemental isotopes at their natural abundances. Forming a peptide bond results in elimination of a molecule of water. Therefore, the protein's mass is equal to the mass of amino acids the protein is composed of minus 18.01524 Da per peptide bond.
=== Lexicon of alcohol and drug terms published by the World Health Organization === The term usually refers to opiates or opioids, which are called narcotic analgesics. In common parlance and legal usage, it is often used imprecisely to mean illicit drugs, irrespective of their pharmacology. For example, narcotics control legislation in Canada, the US, and certain other countries includes cocaine and cannabis as well as opioids (see also conventions, international drug). Because of this variation in usage, the term is best replaced by one with a more specific meaning (e.g. opioid).
Sources: en.wikipedia.org
The dry powder is the stable form and the dissolved form is comparatively fragile. Freezing a solution slows degradation but does not stop it, and repeated freezing and thawing adds further stress. Many laboratories therefore prepare small single-use portions rather than storing one large volume.
It describes the share of the chromatographic signal belonging to the main peak, not the mass fraction of peptide in the vial. Water, counter-ions such as acetate or trifluoroacetate, and residual solvents account for part of the weight of a lyophilized lot. Peptide content by mass is a separate measurement and is often reported alongside purity.
Mass spectrometry is the primary check, because the measured mass can be compared with the expected value for the fifteen-residue chain. Sequence analysis or amino acid composition provides an independent confirmation. Purity testing alone does not establish identity, since a mixture of unrelated short peptides can still produce a clean-looking chromatogram.
It is a synthetic peptide built from fifteen amino acids, with a mass of roughly 1419 daltons. The sequence is reported to match a fragment of a protein present in human gastric juice. It is not a naturally circulating hormone.